Amana AMV9

The Amana® brand AMV9 96% AFUE Two-Stage, Variable-Speed Gas Furnace features our patented, heavy-duty Million-Air™ stainless-steel heat exchanger and recuperative coil. The next-generation SureStart™ silicon nitride Hot Surface Ignition system increases reliability. This furnace is run-tested for heating or combination heating/cooling applications. With a heavy-gauge, reinforced, insulated steel cabinet and durable baked-enamel finish, the AMV9 can be installed in a variety of locations.

Standard Features

• Patented Million Air™ Stainless Steel dual-diameter tubular heat exchanger with lifetime furnace replacement limited warranty
• Two-stage gas valve operates on two-stage or single-stage thermostats
• Super-efficient, ultra-quiet variable-speed circulator motor gently ramps up or down according to heating or cooling demand
• SureStart™ Silicon Nitride igniter with patented adaptive learning routine for maximum igniter life
• Integrated electronic furnace control board with self-diagnostics, low-voltage terminal block, and separate terminals for electronic air cleaner and 120-volt or 24-volt humidifiers
• Low constant fan mode allows the homeowner to activate the lowest available heating speed to circulate air quietly and efficiently throughout the home during the off cycle. This setting costs as little as a 75-watt light bulb to operate.
• Dual-certified for sealed combustion direct vent (2-pipe) or non-direct vent (1-pipe) applications
• Auto-Comfort mode for enhanced dehumidification and energy savings during the cooling months
• All models comply with California NOx emissions standards++

Cabinet Features

• Fully-insulated, heavy-gauge steel cabinet with durable baked-enamel finish
• Designed for multi-position installation: upflow, horizontal left or right
• Airtight solid bottom for side-return applications and easy-cut tabs for effortless removal in bottom air inlet applications
• Convenient left or right connection for gas and electric service
• Coil and furnace fit flush for most installations

Amana AMH95

The Amana® brand AMH95 95% AFUE Multi-Position, Two-stage, Multi-Speed Gas Furnace features our patented, heavy-duty Million-Air™ stainless-steel heat exchanger and recuperative coil. The next-generation SureStart™ silicon nitride Hot Surface Ignition system increases reliability. These furnaces are run-tested for heating or combination heating/cooling applications. With a heavy-gauge, reinforced, insulated steel cabinet and durable baked-enamel finish, these units can be installed in a variety of locations.

Standard Features

• Patented Million Air™ Stainless Steel dual-diameter tubular heat exchanger with lifetime furnace replacement limited warranty
• Two-stage gas valve with revolutionary new TwinComfort™ control technology that allows installer to turn on two-stage operation with the flip of a dipswitch
• SureStart™ Silicon Nitride igniter with patented adaptive learning routine for maximum igniter life
• Energy-saving, quiet four-speed direct-drive circulator blower motor
• Integrated electronic furnace control board with self-diagnostics, low-voltage terminal block, and separate terminals for electronic air cleaner and 24-volt humidifiers
• Control board stores the last five diagnostic codes in memory; simple push-button activation outputs the fault history to a flashing red LED
• Low constant fan mode allows the homeowner to activate the lowest available heating speed to quietly and efficiently circulate air throughout the home during the off cycle
• Self-adjusting feature automatically adjusts furnace to high or low stage based on outside temperature without the need for an outdoor temperature sensor
• Dual-certified for sealed combustion direct vent (2-pipe) or non-direct vent (1-pipe) applications
• Easy-to-install top venting standard; alternate flue/vent located on the right
• Quiet, single-speed induced-draft blower
• All models comply with stringent California NOx emissions standards

Cabinet Features

• Fully-insulated, heavy-gauge steel cabinet with durable baked-enamel finish
• Designed for multi-position installation: upflow, horizontal left or right
• Airtight solid bottom for side-return applications and easy-cut tabs for effortless removal in bottom air-inlet applications
• Convenient left or right connection for gas and electric service
• Coil and furnace fit flush for most installations